The Intelix DIGI-1X4B-1H is a top - notch HDMI distribution amplifier. It comes with four HDBaseT outputs and one HDMI Loop output, making it perfect for distributing an HDMI signal to multiple remote spots. With HDBaseT twisted - pair extension for four outputs, it can send the same signal to a far - off place using an HDBaseT receiver. The HDBaseT ports support up to 4Kx2K HDMI video with audio, wide - band IR tunneling for controlling sources or displays, RS232 tunneling, and HDCP up to 60 meters. Each HDBaseT output port powers the attached extender, removing the need for a power supply at the display end. The HDMI loop - out feature allows cascading to other units for system expansion. A unique control design enables the RS232 port to be addressed and cascaded, letting control commands reach any attached HDBaseT receiver. This helps third - party control systems cut down on COM ports and hardware costs. It's HDMI - compatible, supports up to 4kx2k resolutions, Deep Color, and full 3D. It also has advanced EDID and HDCP handling with preset modes to keep the image consistent across all displays. Key features include one HDMI input, four HDBaseT outputs with PoE and control, one HDMI output for monitors or cascading, the ability to cascade 10 units for 40 total outputs, 1080p and 4Kx2K compatibility, HDCP compliance, diagnostic LEDs, built - in surge protection, bidirectional wideband IR and RS232 routing, and an international power supply with a locking connector.

Using the Intelix DIGI - 1X4B - 1H is straightforward. First, connect your HDMI source to the single HDMI input. Then, you can connect up to four HDBaseT receivers to the HDBaseT outputs, and these will get power directly from the amplifier, so you don't need to worry about extra power supplies at the display end. For a confidence monitor or to cascade more units, use the HDMI loop - out port. If you want to expand the system, you can cascade up to 10 units together. When it comes to control, the RS232 port can be used to send commands to the attached HDBaseT receivers. Just make sure your third - party control system is set up correctly to take advantage of this feature. As for maintenance, keep the amplifier in a clean and dry place. Check the diagnostic LEDs regularly to make sure everything is working fine. If there's a power surge, the built - in surge protection should kick in, but it's still a good idea to use a proper surge protector for the power supply. Also, make sure to use the provided international power supply with the locking connector for a stable power connection.